Vinç kamyonu

Volvo FH 540 8x2 Crane truck w/ 165 t/m HIDROKON crane w

Please state the reference number upon request: 20511

Specifications:

- 2021 model
- 7,350 km (will increase slightly)
- 721 engine hours
- 241 crane hours
- Euro 6 engine
- 8x2 configuration
- 551 HP
- Suspension on 1st and 2nd axles: Steel
- Suspension on 3rd and 4th axles: Air
- 2 x 110 liter variable pumps
- 2 x manual extensions for main boom and 2 x for jib
- Scanreco optical remote control (top model)
- Load cell main boom
- Extra function for main boom and jib
- Auto leveling (The truck automatically levels itself into lifting position)
- Virtual zone (Possibility to limit all axes with just a few button presses; no workshop visit required – ideal for working under high voltage lines, etc.)
- SKF central lubrication for slewing ring and up to the first boom section
- Extra function at the end of the jib
- Single winch hook (jib/main boom)
- Double winch hook (jib/main boom)
- Four-part winch hook (main boom)
- Hook for jib
- Hook for main boom (large hook)
- Emergency lowering unit (24 volts)
- Cable stop sensor and sleeve
- 4-ton winch
- Diagnostic cable for online assistance (remote support)
- Danfoss valve control station
- 2 x 2-ton counterweights (These are only needed for lifting operations over the cab; otherwise, they can be removed as required)
- Front outrigger leg

Structure:

- 4 x work lights, strategically placed in each boom support compartment
- 50" LED work light at the rear of the cab
Dedpfx Aowlm Dteh Decc
- High-performance LED lights on the crane
- VBG mounting with air servo control installed on the left side of the rear cabinet
- Roof rack
- 2 LED auxiliary high beams at the front on the roof (daylight brightness)
- Orange LED work warning bar on the roof
- EasyUp folding ladder with side railing
- Storage boxes for chain signage, etc., mounted on the rear outriggers, allowing deployment with the outriggers and secure storage during transport
- Charger for controls in the cab
- Plastic inner mudguards for axles 3 and 4
- Triangular pull-out storage compartment between axles 3 and 4
- On the left side between axles 2 and 3, there is a large cabinet with a 500 W fan heater for drying clothes, etc.
- Flat/low-closed rear end with door panels made from alloy aluminum, custom-fitted to the vehicle, with rounded edges for a highly professional appearance
- CNC-manufactured panels at the rear of the cab
- Sides, cab, and rear fully painted
- Crane support rest for operation without boom
- 5 outrigger pads: 4 pcs 80x80x6 cm, stored in designated cradles at the rear of the body
- Large cabinet on the right (1.2 x 1 meter)
- ...

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.