Alçak şasi römork

FLIEGL VTS 400 S Luft/ Hydr. 4-Achs Tieflader -904

New Fliegl 4-Axle Low Loader Trailer with Ramps, Model VTS 400

Gross Weight: 24,000kg/40,000kg
Unladen Weight: 8,080kg
Payload: 15,920kg / 31,920kg
Overall Length: 11,940mm
Load Length: total approx. 10,410mm, neck approx. 2,490mm, load bed including rear bevel approx. 7,920mm
Width: 2,550mm
Loading Height: 900mm
Further Information
Plus delivery/preparation ex stock location 26639 Wiesmoor €1,280.00 net

Chassis Low Loader Trailer
Steel welded construction
Turntable with heavy-duty ball bearing ring
Foldable rear support
2 wheel chocks with holder
Aluminum side underrun protection
Full-width rear mud flaps
Partial shell mudguards for 1st and 2nd axles with anti-spray flaps behind each axle, anti-spray flaps in front of and behind the 3rd and 4th axles
Excavator arm recess over the rear axles extending to the rear, approx. 1,800mm long, 650mm wide, and 150mm deep
2 pairs of lashing holes (5t each) located at the side of the main frame in the excavator arm recess, approx. 300mm from the front and approx. 200mm before the rear bevel
1 plastic toolbox, W=600mm / H=425mm / D=460mm, lockable
Recessed storage compartment in the neck area, with lid, W=720mm / L=520mm / D=170mm
Extendable outriggers for width up to 3,000mm (not in the rear bevel)
(Note: the track width of the machinery/vehicles to be transported must not exceed the external frame width of 2,550mm)
Storage compartment for wooden planks under the low bed floor
70mm wooden planks included for widening to 3,000mm
Lashing Points Low Loader
1 pair of tie-down cut-outs in the front longitudinal beams of the neck, 10t each
4 pairs of lashing holes in the outer frame at 5t each (for strap hooks)
9 pairs of lashing pins recessed on the top and sides of the external frame at 10t each
2 at the front on the neck
7 in the lowbed area
First lashing point 250mm from the front, last max. 250mm from the rear, spacing not exceeding 1,100mm
3 additional pairs of folding lashing rings, each rated at 10t
1 on the neck (protruding)
1 at the start of the lowbed area, recessed in the longitudinal members
1 behind the last axle, recessed in the floor
Towing Assembly, Turntable Drawbar
Drawbar with certified 50mm towing eye
Height-adjustable drawbar via spring mechanism
Axles & Suspension
Drum brake axles, manufacturer's choice
"Axle/chassis laser alignment" reduces tire and fuel wear
Air suspension with raise & lower valve + auto-reset function
Wheels and Tires
235/75 R 17.5"
manufacturer’s choice
Steel twin rims, factory silver
Brake System
2-line compressed air brake system
Spring-loaded parking brake
Axle load detection via EBS CAN bus signal, for display in the driver’s cab (requires provisions on truck, not installed, no certified scales)
Vehicle Stability System
2 tamper-proof coupling heads at front, with connection lines to the motor vehicle
12-24 Volt EBS (Electronic Braking System) with EBS plug at front, connection cable; Knorr brand
Pjdpfx Aexrx Nfogyegu
Caution: The trailer may only be towed by tractors capable of ensuring ABS effectiveness!
Electrics
12–24 Volt, multi-chamber LED tail lights, side yellow LED marker lights, LED license plate light
(Note: Certain tractor units may display diagnostic errors despite full functionality)
2 white LED position lights at the front
2 white/red LED lane marker lights at the rear
2 x 7-pin tamper-proof plugs at front, with connection cables
1 LED beacon with bracket, switchable via parking light (removable beacon)
2 pairs...

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.