Alçak şasi römork

FLIEGL DTL 300 Agrar Greenlight Hydraul. 3-Achs Tieflad

Total weight: 24,000kg / 30,000kg
Unladen weight: 5,600kg
Payload: 18,400kg / 24,400kg
Overall length: 10,290mm
Loading length: 5,900mm incl. rear taper
Width: 2,520mm
Loading height: 860mm

Further information

Plus pre-carriage / handling ex stock 26639 Wiesmoor: €1,280.00 net

Chassis: low-bed trailer
Steel welded construction
Turntable with robust ball bearing race
Foldable rear supports
Wheel chocks with holder
Full-width rear mudflaps
1 plastic toolbox
Prepared for extensions to 3,000mm (holes in outer frame with covers, not in the rear taper)
Tie-down eyes for low-bed
1 pair of lashing slots embedded in the front longitudinal member with cranking, each 10t
7 pairs of lashing pins, recessed in the top and sides of the outer frame, each 10t
1x at the front in the cranked area
5x in the low-bed
1x in the rear taper
12 pairs of lashing holes in the outer frame, each 5t (for tie-down straps)
5x cranked area, 6x low-bed, 1x rear taper
Drawbar configuration – turntable trailer
Drawbar with tested 40mm towing eye
Drawbar height adjustable via spring

Axles & suspension
Drum brake axles (manufacturer’s choice)
"Axles/chassis laser aligned" – reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load compensation (rocker balance)

Wheels and tires
235/75 R 17.5"
Manufacturer’s choice
Steel rims, twin configuration, factory silver

Braking system
2-line air braking system
Spring-loaded parking brake
2 non-interchangeable coupling heads at the front, with connection lines to the towing vehicle
Connection lines extended by approx. 60cm
Without ABS, but with mechanical load-sensing valve; maximum approval for 60km/h

Electrics
12 Volt, multi-chamber taillights, no side yellow LED lighting, side reflectors
2 white position lights at front
2 white/red lane marker lights at rear
1x 7-pin 12V plug at front, with connection cable extended by approx. 60cm
1 LED beacon with holder, switched via parking lights (removable lamp)
2 pairs of warning boards, double, LED illuminated and extendable to 3,000mm

Floor
Cranked front area with steel/tread plate covering
Storage box recessed in the drive-over slope towards the cranked section
Then 70mm softwood floor, with steel/tread plate covering in wheel arch areas
Rear taper with 70mm softwood floor
Low-bed loading area incl. rear taper: 5,900mm

Ramps
Prjdpfxewlmr Do Agyjc
Steel ramps 2,800mm long, 750mm wide, laterally adjustable
Wood-covered (tip area with steel/tread plate)
Hydraulically operated, via tractor auxiliary drive with restrictor, controlled from left front side
Hydraulic connection with SVK coupling NW 10/3, incl. connecting hose

Operating instructions
For axle loads of 10,000kg, a special permit is required; only indivisible loads permitted!
The specified total weight is technically possible, but depending on the cargo, the admissible total weight may not be achieved while observing permissible axle, support, and saddle loads (poor driving or tracking may result from incorrect load distribution).

Country of registration / registration plates
Country of registration: Germany
With Dekra inspection and certificate for max. 60 km/h approval, towing vehicle LoF
(With Swiss registration, max. 40 km/h approval possible)
Prepared for two-line license plate holder
No contour marking / reflective strips according to ECE R 048

Paintwork
Frame: RAL 7021 black grey
"10-year anti-corrosion warranty"
Drawbar: galvanized
Ramps: hot-dip galvanize

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.