Alçak şasi römork

FLIEGL DTL 300 Agrar Hydraul. 3-Achs Tieflad

Durumu: yeni, azami yük ağırlığı: 18.400 kg, toplam ağırlık: 24.000 kg, dingil konfigürasyonu: 3 dingil, yükleme alanı uzunluğu: 5.900 mm, yükleme alanı genişliği: 2.500 mm, yükleme alanı yüksekliği: 860 mm, toplam genişlik: 2.520 mm, Total weight: 24,000kg / 30,000kg Unladen weight: 5,600kg Payload: 18,400kg / 24,400kg Overall length: 10,290mm Loading length: 5,900mm incl. rear taper Width: 2,520mm Loading height: 860mm Further information Plus pre-carriage / handling ex stock 26639 Wiesmoor: €1,280.00 net Chassis: low-bed trailer Steel welded construction Turntable with robust ball bearing race Foldable rear supports Wheel chocks with holder Full-width rear mudflaps 1 plastic toolbox Prepared for extensions to 3,000mm (holes in outer frame with covers, not in the rear taper) Tie-down eyes for low-bed 1 pair of lashing slots embedded in the front longitudinal member with cranking, each 10t 7 pairs of lashing pins, recessed in the top and sides of the outer frame, each 10t 1x at the front in the cranked area 5x in the low-bed 1x in the rear taper 12 pairs of lashing holes in the outer frame, each 5t (for tie-down straps) 5x cranked area, 6x low-bed, 1x rear taper Drawbar configuration – turntable trailer Drawbar with tested 40mm towing eye Drawbar height adjustable via spring Axles & suspension Drum brake axles (manufacturer’s choice) "Axles/chassis laser aligned" – reduces tire wear and fuel consumption Parabolic suspension with maintenance-free steel-rubber bushings and mechanical axle load compensation (rocker balance) Wheels and tires 235/75 R 17.5" Manufacturer’s choice Steel rims, twin configuration, factory silver Braking system 2-line air braking system Spring-loaded parking brake 2 non-interchangeable coupling heads at the front, with connection lines to the towing vehicle Isdpfxewlmr De Aggstr Connection lines extended by approx. 60cm Without ABS, but with mechanical load-sensing valve; maximum approval for 60km/h Electrics 12 Volt, multi-chamber taillights, no side yellow LED lighting, side reflectors 2 white position lights at front 2 white/red lane marker lights at rear 1x 7-pin 12V plug at front, with connection cable extended by approx. 60cm 1 LED beacon with holder, switched via parking lights (removable lamp) 2 pairs of warning boards, double, LED illuminated and extendable to 3,000mm Floor Cranked front area with steel/tread plate covering Storage box recessed in the drive-over slope towards the cranked section Then 70mm softwood floor, with steel/tread plate covering in wheel arch areas Rear taper with 70mm softwood floor Low-bed loading area incl. rear taper: 5,900mm Ramps Steel ramps 2,800mm long, 750mm wide, laterally adjustable Wood-covered (tip area with steel/tread plate) Hydraulically operated, via tractor auxiliary drive with restrictor, controlled from left front side Hydraulic connection with SVK coupling NW 10/3, incl. connecting hose Operating instructions For axle loads of 10,000kg, a special permit is required; only indivisible loads permitted! The specified total weight is technically possible, but depending on the cargo, the admissible total weight may not be achieved while observing permissible axle, support, and saddle loads (poor driving or tracking may result from incorrect load distribution). Country of registration / registration plates Country of registration: Germany With Dekra inspection and certificate for max. 60 km/h approval, towing vehicle LoF (With Swiss registration, max. 40 km/h approval possible) Prepared for two-line license plate holder No contour marking / reflective strips according to ECE R 048 Paintwork Frame: RAL 7021 black grey "10-year anti-corrosion warranty" Drawbar: galvanized Ramps: hot-dip galvanize