Alçak şasi römork

FLIEGL VTS 400 Tieflader 4 Achs Rampen Radmulden

Durumu: yeni, azami yük ağırlığı: 31.920 kg, toplam ağırlık: 40.000 kg, dingil konfigürasyonu: 3 aks, yükleme alanı uzunluğu: 10.410 mm, yükleme alanı genişliği: 2.500 mm, yükleme alanı yüksekliği: 900 mm, toplam genişlik: 2.550 mm, New vehicle: Fliegl 4-axle low-loader trailer with ramps, model VTS 400 Total weight: 24,000 kg / 40,000 kg Unladen weight: 8,080 kg Payload: 15,920 kg / 31,920 kg Overall length: 11,940 mm Load length: approx. 10,410 mm in total, gooseneck approx. 2,490 mm, loading bed incl. rear slope approx. 7,920 mm Width: 2,550 mm Loading height: 900 mm Further information: Plus shipping/preparation from warehouse location 26639 Wiesmoor: €1,280.00 net Chassis low-loader trailer Steel welded construction Turntable with robust ball bearing slewing ring Foldable rear supports 2 wheel chocks with holders Aluminium side underrun protection Full-width rear mudflap Half-shell mudguards 1st & 2nd axle with anti-spray flaps behind each axle, Anti-spray flaps in front of and behind 3rd and 4th axle Excavator arm recess over the rear axles extending to the rear, approx. 1,800 mm long, approx. 650 mm wide, approx. 150 mm deep 2 pairs of lashing holes rated 5 t each in the excavator arm recess on the side of the longitudinal frame approx. 300 mm from the front, approx. 200 mm before rear slope 1 plastic toolbox, w=600 / h=425 / d=460 mm, lockable Storage box recessed in the gooseneck floor with lid, W=720 mm / L=520 mm / D=170 mm Extendable widenings to 3,000 mm (not in rear slope) (The track width of construction machinery/vehicles to be transported must not exceed the external frame width of 2,550 mm) Compartment for wooden planks beneath the low-bed platform 70 mm wooden planks for extension to 3,000 mm Low-loader lashing points 1 pair of lashing cut-outs in the front longitudinal beam, integrated into the gooseneck, rated 10 t each Nwedsxrx I Uepfx Afcjb 4 pairs of lashing rings on the external frame, 5 t each (for tensioning strap attachment) 9 pairs of lashing mushrooms, inset on top and side of outer frame, each rated 10 t 2 x front on gooseneck 7 x in the low-bed First lashing ring 250 mm from the front, last max 250 mm from the rear, spacing not greater than 1,100 mm 3 pairs of additional folding lashing rings, rated 10 t each 1 x on gooseneck (protruding) 1 x start of low-bed, recessed in longitudinal beams 1 x inset into floor behind last axle Drawbar equipment for turntable drawbar trailer Drawbar with certified 50 mm towing eye Drawbar height adjustment by spring Axles & suspension Drum brake axles, manufacturer’s choice "Axle/chassis laser measurement" to reduce tire wear and fuel consumption Air suspension with raise and lower valve + auto-reset function Wheels and tyres 235/75 R 17.5", manufacturer’s choice Steel twin tyres, factory silver Brake system 2-line compressed air braking system Spring-loaded parking brake Axle load detection via EBS CAN bus signal, for display in truck cabin; truck must be correspondingly prepared, no truck installation (not a calibrated scale) Vehicle dynamic stability system 2 non-interchangeable coupling heads at front, with connecting lines to tractor unit 12-24 Volt EBS, electronic braking system with EBS connector at front, with connecting cable Brand: Knorr Note: This trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS! Electrics 12-24 Volt, multi-chamber LED lights, side amber LED lighting, license plate illumination in LED (Note! Certain towing vehicles may display diagnostic errors even though function is ensured) 2 white front marker lights in LED 2 white/red lane guidance lights at rear in LED 2 x 7-pin non-interchangeable front connectors, with connecting cable 1 LED rotating beaco