Alçak şasi römork

FLIEGL DTL 300 Agrar Hydraul. 3-Achs Tieflader - 694

Total Weight: 24,000kg / 30,000kg
Unladen Weight: 5,600kg
Payload: 18,400 / 24,400kg
Overall Length: 10,290mm
Loading Length: 5,900mm incl. rear bevel
Width: 2,520mm
Loading Height: 860mm

Additional Information
Surcharge for pre-transport / delivery ex yard 26639 Wiesmoor: €1,280.00 net

Chassis Low-bed Trailer
Steel welded construction
Turntable with heavy-duty slewing ring
Foldable rear support legs
Wheel chocks with holder
Full-width mudflap at rear
1 plastic toolbox
Preparation for extensions up to 3,000 mm (holes in outer frame with covers, not in the rear inclination)
Lashing points, low-bed:
1 pair of lashing slots embedded in front longitudinal beam at kink, 10 t each
7 pairs of lashing points recessed in the upper and side outer frame, 10 t each
• 1 x front at kink
• 5 x in low-bed
• 1 x at rear bevel
12 pairs of lashing holes in outer frame for lashing straps, 5 t each
• 5 x at kink, 6 x in low-bed, 1 x at rear bevel
Towing Device - Turntable Trailer
Drawbar with certified 40 mm towing eye
Drawbar height adjustable via spring
Axles & Suspension
Drum brake axles, manufacturer’s choice
"Axle/chassis laser alignment" — reduces tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load equalization (rocker balance)
Wheels and Tires
235 / 75 R 17.5”
manufacturer’s choice
Bwjdpewm Uy Eefx Ah Hjw
Steel rims, twin configuration, factory silver
Braking System
2-line air brake system
Spring-loaded parking brake
2 non-interchangeable couplings at front with connecting lines to the truck, extended by approx. 60 cm
Without ABS, but with mechanical ALB, then max. 60 km/h approval
Electrical System
12 volts, multi-chamber lights, no side yellow LED lighting, side reflectors
2 white position lights at front
2 white/red outline markers at rear
1 x 7-pin 12V plug at front, with connecting cable, extended by approx. 60 cm
1 LED beacon with holder, switched via sidelights (removable lamp)
Floor
Front kink with steel/chequer plate covering
Storage box recessed in the transition to the kink
Followed by 70 mm softwood flooring, steel/chequer plate covering in wheel arch area
Rear bevel with 70 mm softwood flooring
Low-bed area incl. rear bevel: 5,900 mm
Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Wood-covered (tread end with steel/chequer plate)
Hydraulic, via tractor PTO with restrictor, controlled from left side in front
Hydraulic connection with SVK plug NW 10/3, incl. connecting hose
Operating Instructions
For 10,000 kg axle load, a special permit is required — only indivisible loads allowed!!!
The specified total weight is technically possible; depending on the type of cargo, the total weight may not be achievable while observing the permissible axle/support/king pin loads. (Poor driving/trailing behavior possible due to improper load distribution)
Country of Registration / License Plates
Country of Registration: Germany
With Dekra inspection/certificate for max. 60 km/h approval, towing vehicle LoF
(Country of registration Switzerland: max. 40 km/h possible)
Prepared for two-line license plate holder
Without contour marking/reflection tape according to ECE R 048
Paintwork
Frame RAL 6013 reed green
"10-year warranty against rust-through"
Drawbar galvanized
Ramps hot-dip galvanized

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.