Açık yarı römork

Fliegl 3-Achs Plateausattel teleskopierbar

Chassis, Semi-Trailer, for Freight Forwarding

Fine-grain steel welded construction in lightweight design, fifth wheel plate with replaceable 2" kingpin, main frame reinforced for a central load of 25 tons over 3 m loading length when retracted.

13 pairs of hooks, welded to crossmembers for lashing strap attachment
23 pairs of recessed lashing rings in outer frame, each rated for 3.5 tons
24-ton, 2-speed support winch in reinforced version for uncoupling when loaded, single-side operation
1 spare wheel carrier for 1 spare wheel
1 storage compartment for insert stakes, open, with a socket option behind front wall for storage / or compartment for storage between the extended longitudinal beams
4 pairs of stake pockets recessed in the outer frame, for box section stakes 80x80 mm
5 stake pockets recessed centrally in the floor, for box section stakes 80x80 mm, with reinforcement beams, installed between the outer stake pockets except one
6 lashing/stake rails recessed transversely in the floor, over the full width up to the outer frame (max. usable inside width between the outer insert stakes approx. 2170 mm), approx. 100 mm high. With 20 mm round steel rails, top and bottom, spacing approx. 60 mm (of the round steel). Bottom features angle bracket closure, half open downward. For lashing and staking 80 x 80 mm posts
Rear pull-out ladder, passenger side
5 x 3 pairs of stake pockets recessed in longitudinal beams outside, for 80x80 mm box sections, including reinforcement beams
10 lightweight insert stakes, 80 x 80 mm, usable height approx. 1850 mm, hot dip galvanized, with welded-on lashing rings on both sides at the bottom
2 plastic toolboxes, W=600 mm / H=425 mm / D=460 mm, lockable

Telescoping:
Extendable by max. 4000 mm and lockable every approx. 500 mm
Main frame telescopic
Locking with pneumatic pin locking system + frame locking status indicators on both sides, activation via manual button, operation for brake/locking and suspension on left side in front of axles
Storage compartment between longitudinal beams when extended

Axles & Suspension:
SAF disc brake axles, 430 mm brake disc diameter
Rear axle self-steering, with automatic reversing lock via reverse light and additional manual lock on the vehicle via push button
Axle spacing staggered 1310/1410 mm
Air suspension
1st axle with automatic lift axle, also electrically controllable from the truck, with traction aid

Brake system:
2-line compressed air brake system
Spring-loaded parking brake
2 mistake-proof coupling heads at the front
Wabco EBS, Electronic Brake System with EBS socket at the front
With raise & lower valve + auto-reset function
Axle load detection via EBS CAN bus signal, for display in the truck cab (truck must be pre-equipped)

Wheels and Tyres:
385/65 R 22.5" steel rims

Electrical System:
24-volt, multi-chamber lights, yellow LED side marker lights
2 white front position LEDs
2 white/red rear marker LEDs
2 x 7-pin and 1 x 15-pin mistake-proof sockets at the front
1 revolving beacon with holder, controlled via parking light
2 pairs of LED warning boards illuminated and extendable to 3500 mm
Flashing side marker lights
Side 7-pin sockets: 2x at front wall, 2x at landing gear, 2x at rear end plate
1 additional 7-pin socket in rear underrun guard
Bedpfeza Dyyox Ah Njdc
2 additional LED work lights mounted inside at the front wall, with external switch on left front side
Anti-slip phenolic plywood flooring approx. 30 mm thick
25 mm aluminium hollow section, 1950 mm high, corner posts i

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.