Alçak yükleyici

Fliegl SDS 470 T Standard

Further information
Chassis low-loader semi-trailer
Steel welded construction, fifth wheel plate with replaceable 2” kingpin and 2 kingpin positions,
24 t, 2-speed landing gear, single-sided operation, with straight lower section, without sliding compensation
Rear support foldable
Blodpfxsi Ri E Rj Ah Hjp
2 wheel chocks with holder
Aluminum side underrun protection
Splash guards at rear across entire width
Mudguards in front of 1st axle and behind each axle with anti-spray, according to EU regulations
Extendable width up to 3,000 mm (not in rear slope) (however, the track width of the construction equipment or vehicles to be transported must not exceed 2,550 mm external frame width)
Storage compartment for wooden planks in the center of the loading area
70 mm wooden planks for widening to 3,000 mm
Low-loader lashing points
2 pairs of D-ring lashing eyes, each 5 t, at the front on gooseneck
11 pairs of lashing mushrooms recessed top and side in external frame, each 10 t
2 x on gooseneck
9 x distributed in low-bed deck
first lashing point 250 mm from the front and last max. 250 mm from the rear, distance between lashing points no greater than 1,100 mm
8 pairs of stake pockets recessed in external frame, inside 70 x 40 mm (can be converted to 5 t D-ring lashing eyes, not included)
Axles + suspension
SAF drum brake axles
Axles/chassis laser aligned for reduced tyre wear and fuel consumption
Air suspension
Wheels and tires
235 / 75 R 17.5, make at manufacturer’s discretion
Steel wheels in twin configuration, factory silver
Brake system
2-line compressed air brake system
Color-coded piping for easy maintenance
Spring-loaded parking brake
EBS, electronic braking system with EBS socket at front, without connection cable
Attention: The trailer may only be towed by towing vehicles that ensure the effectiveness of the ABS!
2 fail-safe coupling heads at front, without connection line
with lift & lower valve
Axle load detection via EBS CAN bus signal, for display on the cab monitor; truck must be suitably prepared, not included (not a certified scale)
Vehicle stability control system
Electrics
24 Volt, multifunctional lights, side yellow LED lighting
2 white position lights in front
2 white/red lane marking lights at rear
2 x 7-pin fail-safe sockets at front, without connection cables
1 LED rotating beacon with holder, controlled via parking light (removable beacon)
2 pairs of double warning panels, LED illuminated and extendable to 3,000 mm
Floor
Gooseneck with steel plate covering
Storage box integrated into the transition slope to the gooseneck
Then with 70 mm softwood floor, steel/chequer plate covering in wheel arch area
Rear slope with 70 mm softwood floor
Low-loader area incl. rear slope: 9,200 mm
Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Wood-encrusted
Hydraulic operation via tractor auxiliary drive with restrictor, control on left side of vehicle
Hydraulic connection with SVK coupling NW 10/3, without connecting hoses
Operating instructions
For 10,000 kg axle load, an exceptional permit is required, only indivisible loads permitted!
Special permit required if the allowable towing weight exceeds 40 t!
The total weight stated is technically possible, depending on the load, the total weight may not be achievable within the permitted axle/support/kingpin load limits. (Poor driving and trailing performance possible due to improper load distribution.)
For application of a special permit for regulated heavy haulage, an axle load display is requir

Bu ilan otomatik olarak tercüme edildiğinden bazı çeviri hataları oluşmuş olabilir.